RUIZHOU: The introduction of tool operation parameters (CRT series cutting machine)

Tool operation parameters:

1, [up angle]

When cutting curve arc or the corner, it depends on the angle of the tangent at both ends of the arc to select whether it need to lift the knife or not.

The angle of the tangent at both ends of the arc less than [up angle], it needs to lift the knife, otherwise it doesn’t need.

2, [rolldist]

Corresponding to the displacement that the beam pulls the material into the cutting plane of the machine in the direction of X axis.

3, [start spd]

The higher the value is, the faster the motor will start.

However, restricted by motor performance and external load, the stepping motor cannot be started at a very high speed.

If the motor is blocked at the moment of starting, in the meantime, the value was set too high, the instantaneous current will be too large, and the motor may be burned out. Therefore, the factory has optimized the setting, and it is not recommended to modify.

4, [absorb delay]

How long does the suction start before the machine starts cutting.

Leave enough time for the wind to fully adhere to the material so that deviation doesn't occur during cutting.